APMinerTool User Guide
This tool is applicable to AntMiners and does not support miners from other manufacturers.
Short note: batch monitoring of the state of the miners; static IP configuration; Updating the firmware and restarting the miners.
This tool requires Windows 7 or later. It cannot be used on XP and IOS systems.
The language of the tool will automatically adapt to the system. It will display in Chinese if the system language is Chinese, and will display in English if the system is not in China.
If a virus warning appears during download, we recommend that you try a different browser. The file is absolutely safe.
Unzip the file before use, otherwise errors will occur.
The computer running the tool must be on the same network as the miners. L Static IP address of batch setup (If you have already configured the IP address of the miner, skip this step) The computer and the miner must be in the same IP address range.
Double click to open the software
When the miner is connected to the network and turned on, the IP address obtained when setting up the miner is in DHCP mode and the IP address is not fixed. If you have a lot of miners, this tool can set a static IP in batch so you can better manage those miners.
A typical router’s IP address range is 1-254. If you want to set the miner’s static IP address to 1 to avoid IP conflicts, it is recommended to allow the router to assign an IP address in DHCP mode out of 100. For example: The router assigns an IP address in DHCP mode: 101. -254. ; Static IP for miners: 1-100
Enter the static IP you want to set for the miner as “next addon” and select the coin type for the miner. Set the level pool address, worker and password in the packages in the pool
Configuration section.
Check the “Netmask”, “Gateway”, “DNS” on the computer “Network and Sharing Center” and fill in the appropriate fields.
It is recommended to check the “IP Auto Config” option, a static IP address will be automatically assigned to the next miner in the given order. If this box is not checked, you will need to manually enter the static IP addresses one by one. After completing the above settings, press the report IP button on each miner for 3-5 seconds, the static IP address will be assigned to the miner one by one. The option “IP address and pool configuration at the same time” can be checked depending on your needs.
Quick guide:
- Batch monitoring of the status of miners;
- Static IP configuration;
- Updating the firmware and restarting the miners.
- This tool requires a Windows7 system or higher. It cannot be used in XP or IOS system.
- The language of the tool automatically adapts to the system.
- Unzip the file before use, otherwise there will be errors.
- The computer running the tool must be on the same network as the miners.